While I was in there, I discovered that my receiver has a "standby through" mode which allows me to flip through the three HDMI inputs with the receiver still in standby mode. Initially, I was a little bummed because there was an on-screen display for volume adjustment coming from the receiver-but I was able to turn it off by shutting off the "short message" in the receiver settings. I decided to go ahead and use the receiver as the "hub" as suggested above, plugging in all of my HDMI devices into that, and then sending a single HDMI cable back to the TV. My receiver is a Yamaha RX-V471, with four HDMI inputs. OK, got home and spent the last hour fiddling.įor starters, thanks for the advice. Or, I could get a different brand and see if I have the same issue with that (this CSRET one is the most similar: ). I could just reorder the same Kinivo switch on the off chance the one that I got is defective (although that too seems unlikely since it's highly rated on Amazon). I've got a free return through Amazon for the switch so I'm going to go ahead and do that just to start over-but now I'm uncertain what to do next. I suppose the other possibility is the HDMI cable that connects the switch to the TV, but that's a brand new decent-quality Monoprice one so I kinda doubt that it's defective. I didn't have any issues like this prior to installing the switch, so I'm still leaning toward that as being the culprit. I finally was able to get things working again by unplugging everything and starting fresh. Then I plugged the Chromecast directly into the TV (bypassing the switch) and I got the same sound-but-no-picture. When the screen went gray the second time, I first rebooted the Chromecast, but that resulted in sound but no picture. The second time I tried it, I had similar issues-this time I tried to be more scientific about what was causing the problem, but I had trouble isolating it. I fiddled around with the connections, reset the Chromecast, and was eventually able to watch a 2-hour show without issues. The first time I tried it, the picture would occasionally cut out for a split second, until finally the entire screen went sparkly gray. Right off the bat, I had problems viewing the Chromecast through the switch. I recently got a Kinivo 301BN three-port HDMI switch to use for Blu-Ray and Chromecast (my Panasonic TV has just two HDMI inputs, so I have the cable box plugged into the first one-the switch is plugged into the second one, and the Blu-Ray player and Chromecast are plugged into the switch).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |